This article is a step by step guide to show you have to disable paper removal standby and switch the paper width
Multiple Ticket Printing
- Enter Mode Selection
- Turn off the printer
- Hold down the feed button and power printer on
- Release feed button after ticket prints (Printer Info ticket)
- Hold down the feed button until ticket prints (Mode Selection ticket)
- Enter Customize Value Settings
- Push feed button twice (2) and hold down on the third
- Release feed button after ticket prints (Customize Value Settings)
- Enter Other Settings
- Push feed button thirteen times (13) and hold down on the fourteenth
- Release feed button after ticket prints (Customize Value Settings)
- Enter 5 Paper Removal Standby
- Push feed button five times (5) and hold down on the sixth
- Release feed button after ticket prints (Paper Removal Standby confirmation)
- Verify 5.2 Paper Removal Standby is disabled
- If the asterisk is by 2: Disable skip to step 6, if not continue:
- Push feed button twice (2) and hold down on the third
- If the asterisk is by 2: Disable skip to step 6, if not continue:
Switch Paper Width
- Enter Mode Selection
- Turn off the printer
- Hold down the feed button and power printer on
- Release feed button after ticket prints (Printer Info ticket)
- Hold down the feed button until ticket prints (Mode Selection ticket)
- Enter Customize Value Settings
- Push feed button twice (2) and hold down on the third
- Release feed button after ticket prints (Customize Value Settings)
- Enter Other Settings
- Push feed button thirteen times (13) and hold down on the fourteenth
- Release feed button after ticket prints (Customize Value Settings)
- Enter 3 Switch Paper Width
- Push feed button three times (3) and hold down on the fourth
- Release feed button after ticket prints (Switch Paper Width Options)
- Enter 3.1 40mm/80mm paper size
- If the asterisk is by 1: 40mm/80mm, skip to step 6, if not continue:
- Push feed button once (1) and hold down on the second
- Turn off printer and power back on
- If the asterisk is by 1: 40mm/80mm, skip to step 6, if not continue: